Traxxas Blocks (C-Hubs) 6061-T6 Aluminium Green Anodised RC Caster Block - 7832

The Traxxas TRX7832-GRN caster blocks (c-hubs) are machined from 6061-T6 aluminium and finished in anodized green, offering a direct-fit aluminium upgrade over the standard plastic c-hubs on compatible Traxxas models. C-hubs form a critical part of the front suspension geometry, and switching to machined aluminium units significantly reduces the risk of cracking or deforming under hard bashing or racing use. The anodized green finish adds a distinctive look while also protecting the aluminium from corrosion and wear.

Key Features

• Machined from 6061-T6 aluminium — a high-strength alloy that handles impact and stress far better than standard plastic c-hubs
• Anodized green finish provides corrosion resistance and a clean, consistent colour that won't chip or peel under normal use
• Direct-fit design means no modification is required — these install in place of the factory c-hubs using existing hardware
• Helps maintain consistent caster angle and front suspension geometry under repeated hard impacts

What's Included

• Two 6061-T6 aluminium caster blocks (c-hubs) in anodized green (TRX7832-GRN)

What You Need

• Compatible Traxxas model (refer to Traxxas part fitment guide for models listed under 77036-4, 77096-4, 77097-4, 77136-4, 78086-4, 78097-4)
• Standard hobby screwdrivers or hex drivers for installation
• Existing vehicle hardware (screws and pins reused from factory c-hubs)