Traxxas 18-T 48-Pitch 2.3mm Shaft RC Pinion Gear - 7041

The Traxxas 7041 is an 18-tooth pinion gear designed for Traxxas electric RC models running a 48-pitch gear mesh and a 2.3mm motor shaft. Pinion gears are a core drivetrain component, sitting directly on the motor shaft and driving the spur gear to deliver power to the wheels. The TRX7041 includes a set screw for secure shaft retention, keeping the gear locked in position under load. If you're replacing a worn pinion or re-gearing for a different speed and torque balance, this is a direct Traxxas spare part built to the correct pitch and shaft size.

Key Features

• 18-tooth, 48-pitch pinion gear sized for the standard 2.3mm motor shaft found on many Traxxas electric models
• Set screw included for secure, rattle-free mounting on the motor shaft
• 48-pitch tooth profile must be matched with a 48-pitch spur gear for correct mesh and to avoid premature wear
• Replacing a worn or stripped pinion restores drivetrain efficiency and protects the spur gear from further damage
• Gearing down from a higher tooth count reduces top speed and increases torque; this 18T gear sits at the lower end of the typical pinion range

Compatible With

• Traxxas models fitted with a 48-pitch gear system and a 2.3mm motor shaft — check your vehicle's manual or existing pinion spec before ordering
• Traxxas Bandit
• Traxxas Rustler
• Traxxas Stampede
• Traxxas Slash (where 48-pitch drivetrain applies)

What's Included

• 1 x Traxxas 7041 18-tooth 48-pitch pinion gear
• 1 x Set screw