Hong Nor CNC Ali Upper Arm Holder 'A' 22 Degree RC Suspension Part - X1S-23

The Hong Nor X1S-23 is a CNC-machined aluminium upper arm holder designed as a precision suspension component for the Hong Nor X1S buggy. Machined at 22 degrees, this 'A' variant determines the geometry of the upper suspension arm, making it a key part in setting up or rebuilding the front end of the X1S. CNC aluminium construction gives it greater rigidity and durability compared to a standard plastic holder, which matters when you're pushing an RC buggy hard on rough or technical off-road surfaces.

Key Features

• CNC-machined from aluminium for improved strength and dimensional accuracy over plastic equivalents
• 22-degree angle machined into the holder to set upper arm geometry on the X1S suspension
• Silver anodised finish provides corrosion resistance and a clean look
• Direct-fit part for the Hong Nor X1S using the X1S-23 part number, making sourcing straightforward
• Suitable as a replacement following crash damage or as a geometry-specific setup part

What's Included

• 1x Hong Nor X1S-23 CNC aluminium upper arm holder 'A' (22 degree)

What You Need

• Hong Nor X1S RC buggy (sold separately)
• Any additional hardware or fasteners required for installation (check existing hardware condition before fitting)