Trinity 60T Thin Cut Ultra Lightweight 64P RC Pinion Gear - TEP6160

The Trinity TEP6160 is a 60-tooth, 64 pitch pinion gear designed for competitive RC car racing where minimising rotating mass is a priority. Built to Trinity's thin-cut, ultra-lightweight specification, this 64P pinion reduces drivetrain weight compared to standard-cut alternatives, which can benefit cars running in classes where efficiency and motor response matter. At 60 teeth on a 64P pitch, this gear is suited to lower-speed, higher-torque setups, making it a considered choice for oval, carpet, or technical circuit racing rather than high-speed open configurations.

Key Features

• 60-tooth count on a 64 pitch (64P) spec, suited to torque-focused and lower gear ratio drivetrain builds
• Thin-cut tooth profile reduces overall pinion weight compared to standard-cut 64P gears
• Ultra-lightweight construction targets rotating mass reduction, relevant in competitive racing classes
• Designed for use with 64P spur gears — must be matched to a compatible 64P spur to mesh correctly
• Carries Trinity's TEP6160 part number for straightforward identification and reordering

Compatible With

• Any 1/10 or similarly scaled RC car running a 64 pitch (64P) gear system
• 64P spur gears (spur gear must match 64P pitch for correct mesh)
• Motors with a standard 1/8-inch or 3.17mm motor shaft — verify shaft diameter before fitting

What's Included

• 1x Trinity TEP6160 60T Thin Cut Ultra Lightweight 64P Pinion Gear