RC Car Parts & Spares

Driveshaft, rear, steel constant-velocity (complete assembly) (2)Give your Sledge® the ultimate driveline upgrade with these heavy-duty rear CV (co...

O-rings (6)Set of six O-rings for use with Sledge® rear driveshaftsUse on TRX4-m centre driveshafts

Extension harness, LED lights (high-voltage)Replacement harness extension for the 7885 X-Maxx/XRT LED light kit.

Wheels, wheelie bar, 6061-T6 aluminum (orange-anodized) (2)/ axle, wheelie bar, 6061-T6 aluminum (2)/ 10x15x4 ball bearings (4)Machined from tough ...

Wheels, wheelie bar, 6061-T6 aluminum (green-anodized) (2)/ axle, wheelie bar, 6061-T6 aluminum (2)/ 10x15x4 ball bearings (4)Machined from tough 6...

Wheel nuts, splined, 17mm, serrated (orange-anodized) (4)Set of four 17 mm wheel nuts are serrated for extra bite on the wheel to keep them snug no...

Motor mounts (front and rear)/ 4x10 BCS with split and flat washers (1)/ pin (1) (for installation of #3481 motor into Maxx)New front and rear moto...

Skidplate, center/ 4x20 CCS (4)/ 3x10 CS (4) (fits V2 Maxx with extended chassis (352mm wheelbase))

Battery expansion kit (allows for installation of taller battery packs in Maxx with standard chassis (329mm wheelbase))The battery expansion kit al...

Suspension arm, lower, orange (1) (left, front or rear) (for use with #7895 X-Maxx WideMaxx suspension kit)Heavy-duty WideMaxx® suspension arms uti...

Suspension arm, lower, orange (1) (right, front or rear) (for use with #7895 X-Maxx WideMaxx suspension kit)Heavy-duty WideMaxx® suspension arms ut...

Suspension arms, upper, blue (left or right, front or rear) (2) (for use with #7895 X-Maxx WideMaxx suspension kit)Heavy-duty WideMaxx® suspension ...

Suspension arms, upper, orange (left or right, front or rear) (2) (for use with #7895 X-Maxx WideMaxx suspension kit)Heavy-duty WideMaxx® suspensio...

Differential output cup, center (hardened steel, heavy duty) (2)/ 2.5x12mm pin (2)Give your Sledge® the ultimate driveline upgrade with these heavy...

Wheelie bar, red (assembled)/ 3x20 CS (8)The Sledge® wheelie bar helps prevent backflips under full-throttle acceleration and flexes to absorb impa...

Wheelie bar, green (assembled)/ 3x20 CS (8)The Sledge® wheelie bar helps prevent backflips under full-throttle acceleration and flexes to absorb im...

Stub axles, hardened steel (2) (for use only with #9557 driveshaft) (fits Sledge)Give your Sledge® the ultimate driveline upgrade with these harden...

Toe links, front (TUBES red-anodized, 7075-T6 aluminum, stronger than titanium) (2) (for use with #7895R X-Maxx WideMaxx suspension kit)188 mm TUBE...

Toe links, front (TUBES green-anodized, 7075-T6 aluminum, stronger than titanium) (2) (for use with #7895G X-Maxx WideMaxx suspension kit)188 mm TU...

Transmission, complete (speed gearing) (9.7:1 reduction ratio) (includes Titan® 87T motor)Boost the top end of your TRX-4M™ with this Speed transmi...

ECM-2.5 Electronic Control Module, waterproof (low voltage detection, fwd/rev/brake)ECM-2.5™ features low voltage detection for 2s LiPo batteries a...

Gear set, transmission, high range (trail) (16.6:1 reduction ratio)/ pinion gear, 11-toothDesigned for all-around action, the high-range gear set i...

Driveshafts, center, male (steel) (4)/ driveshafts, center, female, 6061-T6 aluminum (blue-anodized) (front & rear)/ 1.6x7mm BCS (with threadlo...

Wheel hubs, 7mm hex, brass (1 gram each) (4)/ axle pins (8)Set of four brass wheel hubs adds valuable weight to the lowest part of your TRX-4M™ for...